2014年6月18日星期三

Computer Maintenance Trilogy(3)

 
1. Tool prepared a. plum screwdriver (as its name suggests, Xia screws of has, as chassis screws, power screws, graphics screws,) b. Mouser brush (small is small, role big, dust will with) c. alcohol plus cotton (put moderate of alcohol stained in cotton Shang, on cleared Board card Shang of oxidation layer has wonders) d. lens paper, blow balloon (dust), clip
2. The body is ready to put his hands in water pipe or wall, clear body with static electricity, Oh, static and dust but the computer into two "fulltime killer" Oh, so the first dedusting.
3. Cut off the power supply, the host connection between peripherals and unplug, open the chassis Panel with a Phillips-head screwdriver, remove the power supply. At this time, you will see the Board settled on the dirt, hands, blow up balloons to blow see, especially near the inlet of the Panel and the power box (outlet) nearby, as well as the card of the plugging position, more really blew, if there is a small fan, and results would be better.
 4. Plug the power "to pieces", open the "expand" you will see black power supply fan, do not hesitate, this is the power in the dusty camp, after blowing up balloons and tissue paper to clean carefully mounted.
5. The paper clip, insert the optical drive emergency eject hole on the front panel, slightly hard, CD or DVD drive tray opens. The wipe gently with lens paper to clean, be careful not to reach inside the optical drive, and never using the DVD player on my computer "clean" to clean the drive, unless you have a optical drive upgrade plans, hehe.
6. The following floppy disk drive, by blowing up balloons to clear dust from the floppy disk drive.
7. Remove memory and graphics card, check the cheat section is clean, if not clean, clean alcohol available. After cleaning, put back to its original slot again, but note that location is accurate, with socket contact is good.
8. Wipe clean the monitor screen with lens paper, if the display is too dirty, with lens paper dipped in a bit of water (never use alcohol or other cleaning agents) from the inner to the outer rings for cleaning.
9. The back cover of the mouse apart, take out the ball, wash with clean water, dry, dust and clears the internal slider mouse savings and recovery.
10. Use blow up balloons to clear dust between the keyboard keys with a cotton stick the right amount of alcohol for cleaning and disinfection. Note normally keep, frequently for cleaning and disinfection.

没有评论:

发表评论